SNP-G165 160W 3 x 5 inch
Series: SNP-G16
Application: Medical & Health
Form Factor: Open Frame
Type: AC-DC
O/P Voltage: 18V
O/P Current: 8.88A

90~264 VAC Continuous Universal Input

Skynet’s SNP-G Series is a 3″ x 5″ open frame power supply with an amazing power density of 9.4 watts per cubic inch plus active PFC. The 3” x 5” form factor has been an industry standard for more than 10 years. Initially the power density was around 2 watts per cubic inch then hovered around 3 watts per cubic inch for quite some time. Now the SNP-G series in 3″ x 5″ form factor is undoubtedly the current state-of-the-art. With built-in PFC


• With built-in PFC
• Only 1.42 inch height
• 9.4 Watt per cubic inch
• With ITE & Medical safety
• Efficiency between 80% to 90%
• Operation from 0°C to 70°C by convection


3 x 5 x 1.42 inch
76.2 x 127 x 36 mm

DC Outputs

Output, V +18 VDC
Max Load, A  8.88 A / 17.8 A pk.
Regulation  +/-1%
Ripple 120 mV


Input VAC
Voltage, V 90 to 264 VAC
Frequency, Hz 47 to 63
Current, A inrush I <30A at 115VAC;
<60A at 230VAC
Power Factor Active PFC
Harmonics EN61000-3-2, Class D
Cooling Free air convection for 160W
240W w forced air
Power Good Consult Factory
Holdup Time 20 mS typical
at rated load and 115VAC
Transient Consult Factory
Efficiency 80%~90% depending on load
Shorted output Protected
Over Load Protection auto-recovery
Short Circuit Protection auto-recovery
Over Voltage Protection Latch-off
EMS EN61000-4-2, -3, -4, -5, -6, -8, -11
Temperature 0 to 70 degrees C
EMI EN55022 B, EN61000-3-3
Safety Agency UL/CSA/EN60950-1,2nd Edition
ANSI/AMMI/CSA/EN60601-1, 3rd Edition
CB Report, CE Mark, RM rpt


1. The total output current is rated load with free air convection and maximum load. For 240w rating 18 CFM of forced airflow is provided over the unit.
2. Each output is checked at the factory to be within voltage accuracy with a 60% rated load condition.
3. Line regulation is defined by changing the input voltage ±10% from nominal line at rated load.
4. Load regulation is defined by changing the output load ± 40% from 60% of the rated load while another output is set to 60% of rated load.
5. Ripple & noise is measured at rated load and nominal line by using a 15MHz bandwidth limited oscilloscope with each output terminated by a 0.47 uF capacitor.
6. Hold up time is measured from the end of the last charging pulse to when the main output drops down to 95% output voltage.
7. Efficiency is measured at rated load.